Development of aggregate from bottom ash in environmentally friendly concrete

Authors

  • Udomvit CHAISAKULKIET Department of Civil Engineering, Faculty of Engineering, Rajamangala University of Technology Rattanakosin, Nakhon Pathom, 73170 Thailand.
  • Nattapong MAKARATAT Department of Civil and Environmental Engineering Technology, College of Industrial Technology, King Mongkut’s University of Technology North Bangkok, Bangkok 10800, Thailand
  • Sumrerng RUKZON Department of Civil Engineering, Faculty of Engineering, Rajamangala University of Technology Rattanakosin, Nakhon Pathom, 73170 Thailand.

DOI:

https://doi.org/10.55713/jmmm.v32i2.1258

Keywords:

Bottom ash aggregates, Concrete, Water absorption, Chloride penetration, Corrosion, Environmental friendly

Abstract

This research presents a study of bottom ash for using as fine and coarse aggregates in concrete, B-F and B-C, respectively. Results of compressive strength and durability of the concrete containing B-F and B-C aggregates were investigated. Normal fine and coarse aggregates were replaced with the B-F and B-C aggregates at 0, 25, 50, 75 and 100% by weight of the normal aggregates. The results showed that the compressive strengths of the concretes were increased when the B-F and B-C aggregates were used at replacement levels of 25% and 50%. The water absorption and chloride resistances of the concretes were reduced with curing age. Moreover, it was found that the use of B-F and B-C aggregates in concretes effectively improved the compressive strength and the chloride resistances at low replacement levels of 25 and 50%.

Downloads

Download data is not yet available.

References

TR. Naik, “Sustainability of concrete construction,” ASCE Practice Periodical on Structural Design and Construction, vol. 13(2), pp. 98-103, 2008.

C.Meyer, “The greening of the concrete industry,” Cement and Concrete Composites, vol. 31(8), pp. 601-605, 2009.

S. Rukzon and P. Chindaprasirt, “Chloride penetration and corrosion resistance of ground fly ash blended cement mortar,” International Journal of Materials Research, vol. 102(3), pp. 335-339, 2011.

S. Puttala, W. Hiranphattararoj, and S. Homwuttiwong, “Development of a geopolymer made from bagasse ash for use a cementitious material,” Asia-Pacific Journal of Science and Technology, vol. 26(4), 10 pages, 2021.

P. Chindaprasirt, C. Chottitanorm, and S.Rukzon, “Use of palm oil fuel ash to improve chloride and corrosion resistance of high-strength and high-workability concrete,” Journal of Materials in Civil Engineering, vol. 23(4), pp. 499-503, 2011.

P. Chindaprasirt and S. Rukzon, “Strength, porosity and corrosion resistance of ternary blend Portland cement, rice husk ash and fly ash mortar,” Construction and Building Materials, vol. 22(8), pp. 1601-1606, 2008.

S. Rukzon and P. Chindaprasirt, “Strength, porosity, and chloride resistance of mortar using the combination of two kinds of pozzolanic materials,” International Journal of Minerals, Metallurgy, and Material, vol. 20(8), pp. 808-814, 2013.

S. Rukzon and P. Chindaprasirt, “Utilization of bagasse ash in high-strength concrete,” Materials and Design, vol. 34, pp. 45-50, 2012.

S. Rukzon and P. Chindaprasirt, “Strength, Chloride penetration and corrosion resistance of ternary blends of Portland cement self-compacting concrete containing bagasse ash and rice husk-bark ash,” Chiang Mai Journal of Science, vol. 45(4), pp. 1863-1874, 2018.

W. Wongkeo, P. Thongsanitgarn, K. Pimraksa, and A. Chaipanich, “Compressive strength, flexural strength and thermal conductivity of autoclaved concrete block made using bottom ash as cement replacement materials,” Materials and Design, vol. 35, pp. 434-439, 2012.

A. Sathonsaowaphak, P. Chindaprasirt, and K. Pimraksa, “Workability and strength of lignite bottom ash geopolymer mortar,” Journal of Hazardous Materials, vol. 168(1), pp. 45-50, 2009.

R. Kasemchaisiri and S. Tangtermsirikul, “Properties of self-compacting concrete incorporating bottom ash as a partial replacement of fine aggregate,” ScienceAsia, vol. 34, pp. 87-95, 2008.

I. Yuksel, B. Turhan, and O. Ozkan, “Durability of concrete incorporating non-ground blast furnace slag and bottom ash as fine aggregate,” Building and Environment, vol. 42(7), pp. 2651-2659, 2007.

L.B. Andrade, J.C. Rocha, and M. Cheriaf, “Influence of coal bottom ash as fine aggregate on fresh properties of concrete,” Construction and Building Materials, vol. 23(2), pp. 609-614, 2009.

S. Abhishek and G. Khurana, “Strength evaluation of cement concrete using bottom ash as a partial replacement of fine aggregates,” International Journal of Science Engineering and Technology, vol. 3(6), pp. 189-194, 2015.

J. Sanjith, B.M. Kiran, G. Chethan, and K.N. Mohan Kumar, “A study on mechanical properties of latex modified high strength concrete using bottom ash as a replacement for fine aggregate,” International Journal of Emerging Engineering Research and Technology, vol. 3(6), pp. 114-121, 2015.

M. Rafieizonooz, J. Mirza, M.R. Salim, M.W. Hussin, and E. Khankhaje, “Investigation of coal bottom ash and fly ash in concrete as replacement for sand and cement,” Construction and Building Materials, vol. 116, pp. 15-24, 2016.

S. Navdeep, M. Mithulraj, and A. Shubham, “Influence of coal bottom ash as fine aggregates replacement on various properties of concretes: A review,” Resources, Conservation and Recycling, vol. 138, pp. 257-271, 2018.

H.K. Kim and H.K. Lee, “Use of power plant bottom ash as fine and coarse aggregates in high-strength concrete,” Construction and Building Materials, vol. 25, pp. 1115-1122, 2011.

ASTM C33-33M-18, “Standard specification for concrete aggregates, Annual Book of ASTM Standards,” 8 pages, 2018.

ASTM C618-19, “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete, Annual Book of ASTM Standards,” 5 pages, 2019.

C. Jaturapitakkul and R. Cheerarot, “Development of bottom ash as pozzolanic material,” Journal of Materials in Civil Engineering, vol. 15(1), pp. 48-53, 2003.

ASTM C39/39M-21, “Standard test method for compressive strength of cylindrical concrete specimens, Annual Book of ASTM Standards,” 8 pages, 2021.

ASTM C642-13, “Standard test method for density, absorption, and voids in hardened concrete, Annual Book of ASTM Standards,” 3 pages, 2013.

ASTM C1202-19, “Standard test method for electrical indication of concrete’s ability to resist chloride ion penetration, Annual Book of ASTM Standards,” 8 pages, 2019.

S.B. Park, Y.I. Jang, J. Lee, and B.J. Lee, “An experimental study on the hazard assessment and mechanical properties of porous concrete utilizing coal bottom ash coarse aggregate in Korea,” Journal of Hazardous Materials, vol. 166(1), pp. 348-355, 2009.

M. Pasetto and N. Baldo, “Rutting resistance of stone mastic asphalts with steel slag and coal ash,” Sustainability, Eco-efficiency and Conservation in Transportation Infrastructure Asset Management, Losa & Papagiannakis edit. CRC Press, Taylor & Francis Group, London, pp. 31-42 ISBN: 978-1-138-00147-331-42, 2014.

N. Makaratat, S. Rukzon, and P. Chindaprasirt, “Effects of delay time and curing temperature on compressive strength and porosity of ground bottom ash geopolymer mortar,” Journal of Metals, Materials and Minerals, vol. 31(3), pp. 134-142, 2021.

R. Remya, M.M. Paul, and K.A. Aboobacker, “Strength performance of concrete using bottom ash as fine aggregate,” International Journal of Research in Engineering & Technology, vol. 2(9), pp. 111-122, 2014.

A. Yogesh and S. Rafat, “Microstructure and properties of concrete using bottom ash and waste foundry sand as partial replacement of fine aggregates,” Construction and Building Materials, vol. 54, pp. 210-223, 2014.

A. Cadersa, J. Rana, and T. Ramjeawon, “Assessing the durability of coal bottom ash as aggregate replacement in low strength concrete,” Journal of Emerging Trends in Engineering and Applied Sciences (JETEAS), pp. 344-349, 2014.

N. Singh, M. Mithulraj, and A. Shubham, “Utilization of coal bottom ash in recycled concrete aggregates based self compacting concrete blended with metakaolin,” Resources Conservation and Recycling, vol. 144, pp. 240-251, 2019.

M. Tuyan, A. Mardani, and K. Ramyar, “Freeze-thaw resistance, mechanical and transport properties of self-consolidating concrete incorporating coarse recycled concrete aggregate,” Materials and Design, vol. 53, pp. 983-991, 2014.

Downloads

Published

2022-06-30

How to Cite

[1]
U. CHAISAKULKIET, N. MAKARATAT, and S. RUKZON, “Development of aggregate from bottom ash in environmentally friendly concrete”, J Met Mater Miner, vol. 32, no. 2, pp. 101–108, Jun. 2022.

Issue

Vol. 32 No. 2 (2022)

Section

Original Research Articles

License

Copyright (c) 2022 Journal of Metals, Materials and Minerals

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

Authors who publish in this journal agree to the following terms:

    1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.

 

    1. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.