Use of steam explosion as a green alternative method to prepare pulp from pineapple leaves
คำสำคัญ:
Pineapple leaf fibers, Steam explosion, Mechanical properties, Degree of polymerization, Celluloseบทคัดย่อ
The use of agricultural wastes as an alternative form of the cellulosic material to wood has gained considerable attention due to the reduction of deforestation. After cultivation, a large number of pineapple leaves are considered as a waste. Here, the potential steam explosion process was used as a green alternative way to prepare pulp from pineapple leaves without any addition of the chemical treatments. The pineapple leaf fibers were defibrillated from fiber bundles due to the rapid depressurization with the steam pressure between 16 and 20 kgf·cm-2. The partly removal of hemicellulose and lignin associated with the increase of the cellulose content was found from the fibers after introducing the steam explosion process. With increasing the steam pressure, the decrease of the fiber widths and degree of polymerization were observed, and a higher content of cellulose and less contents of hemicellulose and lignin were obtained. The tensile index of the paper was enhanced when the fibers were steam exploded with the higher steam pressure. The paper prepared from the 20 kgf cm-2 steam exploded fibers showed the higher tensile index value of 8.18 Nm g-1 in comparison with that of 4.50 Nm g-1 obtained from the paper of the untreated fibers. In contrast, the lower tear index of the paper made from the fibers steam exploded with the higher steam pressure was found. Pineapple leaf fibers would be possibly used as an alternative material in pulp and paper applications and as a reinforcing agent in composite applications.Downloads
เอกสารอ้างอิง
N. Kengkhetkit and T. Amornsakchai, "Utilisation of pineapple leaf waste for plastic reinforcement: 1. A novel extraction method for short pineapple leaf fiber," Industrial Crops and Products, Vol. 40, pp. 55-61, 2012.
S. Tanpichai, "A comparative study of nanofibrillated cellulose and microcrystalline cellulose as reinforcements in all-cellulose composites," Journal of Metals, Materials and Minerals, Vol. 28, pp. 10-15, 2018.
T. Saowapark, E. Chaichana and A. Jaturapiree, "Properties of natural rubber latex filled with bacterial cellulose produced from pineapple peels," Journal of Metals, Materials and Minerals, Vol. 27, pp. 12-16, 2017.
T. Kittikorn, R. Malakul, E. Stromberg, M. Ek and S. Karlsson, "Enhancement of mechanical, thermal and antibacterial properties of sisal/ polyhydroxybutyrate-co-valerate biodegradable composite," Journal of Metals, Materials and Minerals, Vol. 1, pp. 52-61, 2018.
S. Kaewpirom and C. Worrarat, "Preparation and properties of pineapple leaf fiber reinforced poly(lactic acid) green composites," Fibers and Polymers, Vol. 15, pp. 1469-1477, 2014.
I. Jirapornvaree, T. Suppadit and A. Popan, "Use of pineapple waste for production of decomposable pots," International Journal of Recycling of Organic Waste in Agriculture, Vol. 6, pp. 345-350, 2017.
Annonymous, "cultivation area and quantity of pineapple in Thailand," Office of Argricutural economics, 2017. [online]. Available: http://www.oae.go.th/ [Accessed: Mar. 20, 2019].
S. Tanpichai and S. Witayakran, "All-cellulose composites from pineapple leaf microfibers: Structural, thermal, and mechanical properties," Polymer Composites, Vol. 39, pp. 895-903, 2018.
R. Martin-Sampedro, E. Revilla, J. C. Villar and M. E. Eugenio, "Enhancement of enzymatic saccharification of Eucalyptus globulus: Steam explosion versus steam treatment," Bioresource Technology, Vol. 167, pp. 186-191, 2014.
S. Sabiha-Hanim, M. A. Mohd Noor and A. Rosma, "Fractionation of oil palm frond hemicelluloses by water or alkaline impregnation and steam explosion," Carbohydrate Polymers, Vol. 115, pp. 533-539, 2015.
A. Karakoti, S. Biswas, J. R. Aseer, N. Sindhu and M. R. Sanjay, "Characterization of microfiber isolated from Hibiscus sabdariffa var. altissima fiber by steam explosion," Journal of Natural Fibers, Vol. pp. 1-10, 2018.
S. Tanpichai and S. Witayakran, "All-cellulose composite laminates prepared from pineapple leaf fibers treated with steam explosion and alkaline treatment," Journal of Reinforced Plastics and Composites, Vol. 36, pp. 1146-1155, 2017.
Anonymous, TAPPI test method: The technical association of the pulp and paper industry. 2002-2003.
S. Tanpichai, S. Witayakran and A. Boonmahitthisud, "Study on structural and thermal properties of cellulose microfibers isolated from pineapple leaves using steam explosion," Journal of Environmental Chemical Engineering, Vol. 7, pp. 102836, 2019.
N. Jacquet, G. Maniet, C. Vanderghem, F. Delvigne and A. Richel, "Application of steam explosion as pretreatment on lignocellulosic material: A review," Industrial & Engineering Chemistry Research, Vol. 54, pp. 2593-2598, 2015.
B. M. Cherian, A. L. Leao, S. F. de Souza, S. Thomas, L. A. Pothan and M. Kottaisamy, "Isolation of nanocellulose from pineapple leaf fibres by steam explosion," Carbohydrate Polymers, Vol. 81, pp. 720-725, 2010.
N. Phinichka and S. Kaenthong, "Regenerated cellulose from high alpha cellulose pulp of steamexploded sugarcane bagasse," Journal of Materials Research and Technology, Vol. 7, pp. 55-65, 2018.
M. Li, G. Han, Y. Song, W. Jiang and Y. Zhang, "Structure, composition, and thermal properties of cellulose fibers from pueraria lobata treated with a combination of steam explosion and laccase mediator system," Bioresources, Vol. 11, pp. 6854-6866, 2016.
G. Han, J. Deng, S. Zhang, P. Bicho and Q. Wu, "Effect of steam explosion treatment on characteristics of wheat straw," Industrial Crops and Products, Vol. 31, pp. 28-33, 2010.
A. Kaushik and M. Singh, "Isolation and characterization of cellulose nanofibrils from wheat straw using steam explosion coupled with high shear homogenization," Carbohydrate Research, Vol. 346, pp. 76-85, 2011.
E. A. Hassan, M. L. Hassan and K. Oksman, "Improving bagasse pulp paper sheet properties with microfibrillated cellulose isolated from xylanase-treated bagasse," Wood and Fiber Science, Vol. 43, pp. 76-82, 2011.
N. H. M. Hassan, S. Muhammed and R. Ibrahim, "Properties of Gigantochloa scortechinii paper enhancement by beating revolution," Journal of Tropical Resources and Sustainable Science, Vol. 2, pp. 59-67, 2014.
R. S. Seth and D. H. Page, "The stress-strain curve of paper," in Book, J. Brander, Eds. London: Mechanical Engineering Publ. Ltd., 1983.
D. H. Page and R. S. Seth, "The elastic modulus of paper 2. The important of fibre modulus, bonding, and fiber length," Tappi, Vol. 63, pp. 113-116, 1980.
D. H. Page, R. S. Seth and J. H. Degrace, "The elastic modulus of paper 1. The controlling mechanisms," Tappi, Vol. 62, pp. 99-102, 1979.
S. Tanpichai, W. W. Sampson and S. J. Eichhorn, "Stress-transfer in microfibrillated cellulose reinforced poly(lactic acid) composites using Raman spectroscopy," Composites Part A: Applied Science and Manufacturing, Vol. 43, pp. 1145-1152, 2012.
S. Tanpichai and J. Wootthikanokkhan, "Reinforcing abilities of microfibers and nanofibrillated cellulose in poly(lactic acid) composites," Science and Engineering of Composite Materials, Vol. 25, pp. 395-401, 2018.
M. Guan, X. An and H. Liu, "Cellulose nanofiber (CNF) as a versatile filler for the preparation of bamboo pulp based tissue paper handsheets," Cellulose, Vol. pp. 2019.
ดาวน์โหลด
เผยแพร่แล้ว
วิธีการอ้างอิง
ฉบับ
บท
การอนุญาต
ลิขสิทธิ์ (c) 2019 Journal of Metals, Materials and Minerals
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Authors who publish in this journal agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
